User's Manual

SW-ATT-TAKRF preliminary manual 04-18-2012 RevB.docx

Page 7 of 7

6. RF signals can be affected by metal objects including metal doors or large mirrors. Care

should be taken to avoid these objects during installation as they can interfere with

proper operation.

FCC compliance statement

This device complies with FCC Rules and Regulations as Part 15 devices as well as Industry

Canada Rules and Regulations. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may

cause undesired operation. Changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to operate the

equipment.

Conformité Réglementaire

Ce dispositif est conforme à la réglementation de la IC et (Partie 15) de la FCC. Son

fonctionnement est soumis à deux conditions : (1) ce dispositif ne doit pas causer

d’interférences nuisibles, et (2) ce dispositif doit accepter toute interférence reçue, y

compris les interférences pouvant entraîner des conditions de fonctionnement

indésirables.

WARNING: The polarity of the battery must be observed. Improper handling of

lithium batteries may result in heat generation, explosion or fire which may lead to

personal injuries. Replace only with the same or equivalent type of battery as

indicated in the General Specifications.

Batteries should not be recharged, disassembled or disposed of in fire.

Disposal of used batteries must be made in accordance with the waste recovery and

recycling regulations in your area.

Notice to users in California—CR Coin Cell Lithium Battery information: This

product contains a CR Coin Cell Lithium Battery which contains Perchlorate

Material—special handling may apply See