User Manual

OVERVIEW USER MODE ADMIN MODE MANAGING DRIVE CONTACT & WARRANTY
SecureDrive KP User Guide ▪ 9
2.13.2020
Creating an Admin PIN (User PIN Exists)
STEPS
LED
ERROR STATE
Press .
-
Enter the User PIN.
-
Press .
-
Wait for , then press and hold down 1-and then
press- .
-
Enter a new Admin PIN.
If an error occurs:
+
Press .
-
Re-enter your new Admin PIN.
-
Press .
- briefly
Then 
+
If unsuccessfull, LEDS will
immediately be:
+
Note: If a mistake was made or the procedure not completed, no Admin PIN will be created.
Unlocking the Drive in Admin Mode
CAUTION: Possible deletion of all data, settings, and both PINs. After ten failed attempts to unlock
the Drive, it will reset to a blank factory setting. Refer to Brute Force Hacking Detection on page 14.
STEPS
LED
ERROR STATE
Press and hold down 1-and then press .
-
Enter the Admin PIN.
-
Press .
- briefly
Then 
+
- if error, the red LED fades out
then turns solid.
Note: If your computer goes into sleep mode while the Drive is unlocked, the Drive may lock after some
time depending on your power management settings regarding the USB port.