User Manual

OVERVIEW USER MODE ADMIN MODE MANAGING DRIVE CONTACT & WARRANTY
SecureDrive KP User Guide ▪ 12
2.13.2020
Setting the Timeout Lock in Admin Mode
To protect against unauthorized access when the Drive is connected to a computer and idle, it can be set to
automatically lock after a preset amount of time.
In its default state, the Timeout Lock feature is turned off. It can be set to activate (lock the Drive) any time
between 1 and 99 minutes. Admin Timeout Lock settings will override User settings.
STEPS
LED
ERROR STATE
Press and hold down 1-and then press- .
-
Enter the Admin PIN.
-
Press .
- if error, the red LED fades out
then turns solid.
Wait for , then press .
-
Press 8, 5. (T, L for Timeout Lock).
-
Press .
If an error occurs:
fast + slow
Enter the length of unattended time for Timeout.
Two digits required.
Examples: 01 = 1 minute
99 = 99 minutes
-
Press .
- briefly,
then 
fast + slow
If an error occurs:
fast + slow
If successful, the Timeout Lock is now set.
Disabling the Timeout Lock in Admin Mode
Follow the same steps for setting the Timeout Lock (above) and enter 00 for the time delay. The Timeout
Lock will be disabled.