User Manual

OVERVIEW USER MODE ADMIN MODE MANAGING DRIVE CONTACT & WARRANTY
SecureDrive KP User Guide ▪ 13
2.13.2020
SECTION 4: Managing the Drive
The following headings discuss important, though less common, actions for managing your Drive. Except
where noted, all procedures assume your Drive is connected to a computer and locked (red LED).
Verifying which PINs have Been Set
To determine which PINs have been set:
Press ; These LEDs display for 10 seconds:
 No PIN exists. [ ]
 Only User PIN exists. [ ]
 Only Admin PIN exits. [ ]
 Both PINs exist. [ ]
Deleting all Files in Admin Mode
An Administrator can delete all data stored on the Drive including User settings and PIN. All Admin settings
(and only the Admin settings) will remain on the Drive. For further use, the Drive will need to be
reformatted. For reformatting, refer to Reformatting the Drive on page 16.
CAUTION: The ‘Delete All’ procedure deletes all data, User settings, and formatting. The Drive must
be reformatted for further use.
Note: All procedures under this heading start with the Drive plugged into a computer. Each step in all
procedures below has a 10 second window to start the step after it. In general, a resulting status (indicated
by the LEDs) times out after 10 seconds.
STEPS
LED
ERROR STATE
With the Drive locked, press and hold down 1-and
then press- .
-
Enter the Admin PIN.
-
Press .
- if error, the red LED fades out then
turns solid.
Wait for , then press .
-
Press 3, 2. (D, A for Delete All)
-
Press .

alternating
If an error occurs:
fast + slow
Enter the Admin PIN again.

alternating
-
Press .
- momentarily,
then 
fast + slow
If an error occurs:
- briefly, then 
fast + slow
All data and User settings have now been deleted from the Drive.