User Manual

OVERVIEW USER MODE ADMIN MODE MANAGING DRIVE CONTACT & WARRANTY
SecureDrive KP User Guide ▪ 15
2.13.2020
Resetting (Deleting) the Drive
CAUTION: Resetting the Drive will delete all data stored on it including both PINs. After Resetting,
the Drive must be formatted (initialized).
In the event that both the Admin and User PINs have been forgotten, or you want to delete all data stored
on the Drive including the PINs, you can perform the following Reset function. It also removes the
encryption, requiring the Drive to be reformatted—to format the Drive refer to the heading Reformatting
the Drive
on page 16.
STEPS
LED
ERROR STATE
With Drive locked, press and hold down 7-and then
press .

alternating
-
Press 999.

alternating
-
Press and hold down 7-and then press .
&
momentarily
- if error, the red LED fades out then turns
solid.
The Drive is now blank and locked.
Creating a User PIN after a Reset (Blank Drive)
Follow this procedure when the Drive is blank: such as after it has been reset or Hacking Detection has
triggered.
STEPS
LED
ERROR STATE
Connect the Drive to your computer with the
USB cable.
-
-
Press .
-
Wait four (4) seconds, press .
-
Enter new User PIN.
-
Press .
-
Re-enter the new User PIN.
-
Press .
Fades out 
If error: Fades out 
Note that the Drive still requires formatting.