Operating instructions

5
201114-01
UP
EAVE INSTALLATION
INFORMATION
IMPORTANT:Forundereaveinstallationonly,the
sensorheadmustberotatedasshowninthenext
twostepsforproperoperationandtoavoidthe
riskofelectricalshock.For proper under-eave
operation, install light shield (included). See
Light Shield Installation for details.
1. Rotate the sensor head towards the clamp
screwjoint(seeFigure8).
2. enrotatethesensorheadclockwise180°so
thecontrolsfacedown(seeFigure9).
Note:Ifthesensorpopsoutoftheballjoint,loosen
theclampscrewandpushthesensorbackintothe
balljoint.Tightentheclampscrewwhendone.
Figure 7
Figure 10
Canopy
Extension
Caulk Upper Half of Canopy Extension
BULB INSTALLATION AND
REPLACEMENT
Left
Socket
Right
Socket
Contact
Bulb Lamp Head
1
2
CAUTION: When replacing bulb, turn
power o and let the xture cool.
NOTE: The bulb is included, but need to be
installed. The bulb is located behind the glass
cover of the lamp head.
1. Removeglasscoverandremovetheoldbulb
bypushingthebulbtowardstherightuntil
the leftside of the bulb is clear of the left
socket.
2. Toinstallthebulb,placeoneendofthebulbon
thecontactintherightsocket.Whilepushing
thebulbagainsttherightcontact,lowerthe
otherendofthebulbontothecontactinthe
leftsocket.
3. Spinthebulbtoverifyitisseatedproperly.
4. Re-installtheglasscover.
For proper operation and safety, the light
xture must be above the sensor and the sen-
sor head must be rotated so that the controls
are on the bottom.
Important: Use a clean glove or cloth when
handling the new bulb. Use isopropyl (rubbing)
alcohol to clean the bulb if it is touched with
your bare hands.
Rubber Plug
Clamp Screw
Controls
Controls
Controls
Light
Shield
Figure 8
Figure 9