Operating instructions

7
201114-01
Note:Whenrstturnedonwaitabout1
1
/
2
minutes
forthecircuitrytocalibrate.
*resetstoAutoModeatdawn.
OPERATION
MANUAL MODE
Mode: On-Time Works: Day Night
Test
5Seconds x x
Auto
1,5,or10
Minutes
x
Manual
ToDawn* x
... back on.
1 Second
OFF then...
Manual mode only works at
night because daylight returns
thesensortoAUTO.
Flipthelightswitchoforone
secondthen back on to toggle
betweenAUTOandMANUAL
MODE.
Manualmodeworksonlywith
theON-TIMEswitchinthe1,
5,or10position.
MANUAL MODE
AUTO
TEST
ON-TIME Switch at 1, 5,
or 10 minutes
MODE SWITCHING SUMMARY
Flip light switch
o for one second
then back on*
*Ifyougetconfusedwhileswitchingmodes,turn
thepoweroforoneminute,thenbackon.After
thecalibrationtimethecontrolwillbeintheAUTO
mode.
LIGHT SHIELD INSTALLATION
Ifyourlightdoesnotcomeonatduskorturns
ounexpectedly,thenanotherlightsourcemay
beactivatingthedaytimeshutofeature.Possible
sourcesoflightinterferencearestreetlights,land-
scapelighting,othersecuritylightsorlanterns,or
aninteriorhouselightshiningthroughawindow.
Itcouldalsobereectivelight,suchasfromapool
orlightcoloredwall.
To install the light shield, follow these simple
steps.
1. Removeprotectivebackingfromthebottom
ofthelightshield.
2. Positionlightshieldoverthephotocellwith
theopeningfacingawayfromtheinterfering
light.
3. Press the adhesive side rmly against the
photocelltomountitpermanentlyinplace.
Protective
Backing
Light
Shield