Installation Instructions

ManualsBrandsSecuritron ManualsComputers & AccessoriesPower Supply 6A DV with Enclosure, (1) B100, (1) D8

Before connecting the Securitron Netlink to a network for the first

time, the board must be configured using a laptop.

All screens shown are of the NL4 GUI. screens are similar, with changes as noted in the text.

If using DHCP, a Network Scan Tool used for finding Securitron devices is available at http://www.lifesafetypower.com/support/software-firmware-downloads

Preparing to configure

the Securitron

Netlink board

In order to perform the initial configuration of the

Securitron Netlink, you will need the following:

• A computer (PC or Mac) set to a static IP address in the

subnet 192.168.1.xxx, where xxx is a subnet address

(0 to 255) not being used by any other device on the

network. Do not use 192.168.1.9 or the final IP address

you will be using for the Securitron Netlink. Disable

any active WiFi connections. See image on right.

• A web browser installed on the computer.

• A standard (not crossover) Ethernet

cable long enough to reach between the

computer and the Securitron Netlink.

• The Securitron Netlink to be configured must be

wired into the system and powered. After powering

the Securitron Netlink, wait for it to initialize -

when ready, the blue SYS LED will be lit steady.

• After the Securitron Netlink is powered

within the system and initialized, connect the

Ethernet cable between the Ethernet ports of

the computer and the Securitron Netlink.

Logging into the

Securitron Netlink

for the first time

From the factory, the Securitron Netlink

is preset with the following settings:

• IP Address: 192.168.1.9

• Username: admin

• Password: admin

Open a browser on the computer and enter the IP

address into the address bar. When propted, enter the

user name and password. Note that BOTH are case

sensitive. The Securitron Netlink License Agreement

and one or more Cybersecurity windows will also

appear. Read these and click OK (next page). The

home page for the Securitron Netlink should appear

in the browser window. See image next page.

NOTE: If the wrong password is entered three consecutive

times, the user will be locked out of the device for the

programmed lockout time (24 Hours by default). Enter

the password carefully to avoid lockout. This time

period may be changed on the configure page.

Example of a PC Ethernet Port settings Window

Securitron Netlink Login Window

(may appear different , depending on browser)