Installation Instructions

Select the Occurrences to Report
The “Select Occurrences to Report” block of the
Reporting page allows the setting of the number of
history events to be included in the report file attached
to the alert email (example right). The Securitron
Netlink records a snapshot of device parameters at
the time period selected on the Configure page. Up
to 1000 history events can be recorded. The user can
enter between 1 (the latest event only), up to 1000 (for
all events). After entering the number of history events
to email, click the Submit button to save this setting.
Select the Devices and
Parameters to Report
The bottom section of the Reporting page contains
the devices and parameters selection area. Any
connected devices will show here, along with
a section for the Securitron Netlink itself.
The Securitron Netlink and each device also have
selectable parameters listed below their headings.
Checking these parameters will add them to the
report attached to the email alert. These are the
same parameters as seen on the Home page.
Available Securitron Netlink parameters
include: enclosure temperature, external
temperature, current sensor readings, the ADC1
reading, and the Event Status (these may appear
as the labels set on the Configure page).
Available Securitron AQL parameters include:
Model Number, System Fault Status, AC Fault Status,
FAI Status, FAI Latch Status, Securitron AQL Output
Voltage, Battery Voltage, Battery Charge Current,
Total Power-up time, Battery Installed time, AC Fault
Total, System Fault Total, Battery State Of Charge,
Battery Runtime Test Total, Battery Runtime Test
Failed Total, Required Standby, and Actual Standby.
After setting the devices and parameters to be reported,
be sure to click the Submit button for each device.
Typical Reporting Page
31