Installation Instructions

Network Module Data, History & Control Sections
Below the Basic Site Information are the parameters and settings related
to the Securitron Netlink board and the Web Interface itself.
Enclosure Temperature
This is the temperature of the Securitron Netlink board. This temperature
sensor is installed on the Securitron Netlink's PC board.
External Temperature
If an external temperature sensor is connected to J18, this temperature
display will display the external sensor's temperautre.
Current Sensor
Measurements
These will appear as the labels you set for the Current Sensors on the Configure page.
These measurements are shown as a positive or negative current in Amps DC.
A positive current measurement indicates current flow from the longer red lead
of the current sensor to the shorter orange lead of the current sensor. If current
is being displayed in the opposite polarity than expected, swap the short and
long red leads. See page 21 for more information on the current sensor.
ADC Voltage
Measurement
This is the voltage measured by the on-board Analog-to-Digital converter (ADC)
and will appear as the label you set for the ADC input on the Configure page.
This measurement is shown as a positive or negative voltage in Volts DC.
Event1 Indicator
This field shows the status of the Event1 input. It will appear as the label set for the
Event1 input on the configure page. This field will show "Active" on a yellow background
or "Inactive" on a green background to indicate the status of the Event1 input.
Service Due
This field will display "Yes" when the "Next Service Due" date programmed on
the Configure page has been reached and will display "No" before the due date.
If the "Service Due" checkbox is enabled on the Reporting page, the color of the
"Service Due" field will be blue if service is required or green if not required.
Control 1 & Control
2 Status
These fields indicate the state of the two control outputs of the Securitron Netlink. These
control ouputs will be labeled with the names given on the Configure page and can be
changed with the Output Control radio buttons to the right. The Control 1 and Control
2 fields will display "Off" with a gray background or "On" with a green background.
View/Export History
The Securitron Netlink saves a snapshot of data at the programmed interval. These snapshots
can be reviewed by entering the number of events to view or export then clicking the View
Data button. To view only the detected fault data, check the Fault Data Only box before
clicking View Data. There are up to 1000 events available for review. To save the data, click the
Export to CSV File button. Click the Return button at the top to return to the home page.
Device On/Off Control
These two pairs of radio buttons select the state of the two Control Outputs
of the Securitron Netlink board. After changing the radio button, the Submit
button must be clicked for the setting to take effect. The labels entered for
these outputs on the Configure page appear below the radio buttons.
Temperature
This changes the display of the Securitron Netlink temperature between Celsius and Fahrenheit
on the browser display. The Submit button must be clicked for this setting to take effect.
33