Installation Instructions

call
[phone]
or email
[e-mail]
NEED
HELP
Two-Year Limited Warranty
Visit securitybrandsinc.com/warranty/ for details
1 2 3 4 5 6 7 8 9 0 ON
INSTRUCTIONS
2 of 2
Model 14-R300
© 2021 Security Brands, Inc. All rights reserved. I-14R300-EN Rev. A (5/2021)
WARNING! AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK THAT THE GATE PATH IS
CLEAR BEFORE OPERATING!
REVERSING OR OTHER SAFETY DEVICES
SHOULD ALWAYS BE USED!
3.
corresponding to button you want to program.
NOTE: Pay attention to the markings on the
circuit board showing which set of DIP switches
corresponds to which button.
4. Set DIP switches to match those set on receiver.
5. Repeat procedure for second button if desired.
Otherwise, close unit and secure with screws.
NOTE: The second button can be paired with the
HOW TO USE
1. Make sure you are in range of 300-MHz receiver
you want to control.
2. Press remote button linked to desired receiver.
LED should light.
3. Receiver will respond and operate gate/door.
NOTE: If the receiver does not respond, make sure it
has power and that the remote LED is lighting when
a button is pressed. If not, check the battery. If the
receiver still does not respond, make sure its antenna
is not inside a metal box, the DIP switch positions
match on both remote and receiver, and if it is a
third-party receiver, make sure the frequency jumper
is in the 300-MHz position.
(default positions for both buttons)
３００－ ＭＨｚ Ｔｒａｎｓｍｉｔｔｅｒ
Find DIP switches on 300-MHz Transmitter unit
DI P Sw it c he s on 3 0 0 -M H z Tra nsm it t e r