Installation Instructions

QUICK START GUIDE
3 of 6
7
Add Access Code(s) to Channel A.
(To add multiple codes, enter each of them before pressing pound key)
6b
Pair keypad unit with receiver by entering
sequence below on keypad.(Make sure 9-V
battery is connected on keypad unit)
A1
Additional programming
6c
While pairing, keypad unit will beep and flash
Once receiver LED goes out and “good” tone is
heard on keypad unit, pairing is complete.
LED will
go out
9
LED will light
solid orange
6a
Remove receiver cover; then
hold down Programming button on
circuit board for 3 seconds and let go.
8
Make sure gate path is clear; then
enter access code on keypad and
con firm gate opens.
(If keypad locks up, repeat Step 6
)
1 1
2
5
5
?
? ? ?
Unique Keypad ID
(4 digits; numbers only)
Master Code
(can be changed)
91 1
2
5 ?
Master Code
(can be changed)
Channel
(1 for A, 2 for B)
1
1 1
2 5 ?
?
? ?
Access Code(s)
(4 digits; numbers only)
Master Code
(can be changed)
Sub Mode
21 1
2
5 ? ?
?
?
Code(s) to Be Deleted
(4 digits; numbers only)
Master Code
(can be changed)
Sub Mode Sub Mode
Your system is ready to use.
INSTALLATION COMPLETE!
NOTE: Green arrow indicates “good” tone on keypad unit.
NOTE: The Master Code is for programming only and will not trigger the relay.
Delete Code(s)
(To delete multiple codes, enter each of them before pressing pound key)
NOTE: Green arrow indicates “good” tone on keypad unit.
Always wait for good tone before moving on.
Set Unique Keypad ID
(Allows multiple keypad units and receivers to be used. If Keypad ID is changed,
keypad unit and receiver must be paired again.)
Model
14-REC20