User manual

10
www.supercircuits.com
SECTION 2: INSTALLATION AND SETUP
On the MD AREA screen, press Play/Pause to select a mode for enabling or disabling cells to monitor
for motion. A pop-up menu will open:
CELL EDIT – for enabling/disabling motion detection in one cell at a time.
DEL BLOCK – disables a block that was previously congured for motion detection.
DEL ALL – disables all cells for motion detection.
ADD BLOCK – enables a block for motion detection
ADD ALL – enables motion detection in all cells
Use the p, q, u, and t buttons to select a cell, and press Enter to select or deselect the cell for
monitoring.
MD SENSITIVITY
The MD SENSITIVITY screen allows you to adjust the energy threshold at which recording is triggered
when motion is detected within the cells enabled for motion detection. Using this feature, you to setup
the DVR to ignore small objects moving through the cell eld (low MD ENERGY level), and detect and
record when large objects are moving there.
MD ENERGY
Level (Black)
MD
THRESHOLD
Marker (Red)
On the MD SENSITIVITY screen, the MD ENERGY value is a measure of how much motion is detected.
The MD THRESHOLD is adjusted using the u (+) and t (–) keys. Recording is triggered when the MD
ENERGY level exceeds the MD THRESHOLD.