Programming instructions

Digital Monitoring Products XR200-485 Programming Guide
4
INTRODUCTION
XR200-485 Programming Guide Digital Monitoring Products
5
INITIALIZATION
Initialization
2.1
INITIALIZATION
Initialization
This function allows you to clear and return selected parts of the panel program
back to the factory defaults in preparation for system programming.

 

 










 


2.2
INIT ALL? NO YES
SURE? YES NO
Clear All Memory
NO - Leaves existing programming intact.
YES - Clears all memory.
2.3
CODES? NO YES
SURE? YES NO
Clear All Codes
NO - Leaves existing codes intact.
YES - Clears the user code memory and assigns the user code number 99 to the
highest user position in each partition.
2.4
SCHEDS? NO YES
SURE? YES NO
Clear All Schedules
NO - Leaves existing schedules intact.
YES - Clears all primary, secondary, permanent, temporary, and output schedules.
2.5
EVENTS? NO YES
SURE? YES NO
Clear Display Events Memory
NO - Leaves existing event memory intact.
YES - Clears the Security Command keypad display events memory.
2.6
ZONES? NO YES
SURE? YES NO
Clear Zone Information
NO - Leaves existing zone information intact.
YES - Clears the zone information for all zones. All zones are marked * UNUSED *
and must be renamed before being able to display on any system keypad.
2.7
AREAS? NO YES
SURE? YES NO
Clear Area Information
NO - Leaves existing area information intact.
YES - Clears the area information for all areas. All areas are marked * UNUSED * and
must be renamed before being able to display on any system keypad.
2.8
OUTPUTS? NO YES
SURE? YES NO
Clear Output Information
NO - Leaves existing output information intact.
YES - Clears all programmed Output names and any output cutoff assignment.
2.9
COM/RMT? NO YES
SURE? YES NO
Clear Communication and Remote Options
NO - Leaves existing communication and remote options intact.
YES - Clears communication and remote options programming to factory defaults.
2.10
DEFAULTS NO YES
SURE? YES NO
Set to Factory Defaults
NO - Leaves existing panel programming intact.
YES - Sets the remainder of the panel programming back to the factory defaults.