Programming instructions
Digital Monitoring Products XR200-485 Programming Guide
16
REMOTE OPTIONS
XR200-485 Programming Guide Digital Monitoring Products
17
REMOTE OPTIONS
5.7
SVC REC NO YES
Service Receiver Authorization
YES enables remote commands and programming to be accepted from a secondary
service receiver other than the alarm SCS-1/SCS-1R Receiver. The Remote Key
option can also be required.
With YES selected, the panel requests the service receiver key the rst time it is
contacted by the service receiver. The panel retains this service receiver key in
memory and accepts remote commands from the service receiver.
If an alarm occurs during a remote connect, the panel disconnects from the service
receiver and calls the alarm receiver. Alarm reports are only sent to the alarm
receiver. It is important that the alarm receiver key and the service receiver key
programmed at the central station are NOT the same so the panel can determine the
difference between receivers.
When NO is selected remote commands and programming are not accepted from a
secondary service receiver.
This option must be YES to allow programming from a directly connected computer
or an iCOM or iCOM-E.
5.8
-
-
REMOTE PHONE NO
Remote Phone Number
Press COMMAND to enter the phone number the panel dials whenever remote
programming is requested. After entering a phone number, the panel allows remote
commands and programming only after it is rst called by the authorized receiver,
disconnects itself, and redials the remote phone number.
If a Remote Phone Number is NOT entered, and Alarm Receiver and Service Receiver
is YES the panel allows remote commands and programming without disconnecting
and redialing. The phone number can be up to two lines of 16 characters to equal
32. Enter a D for dial tone detect and a P for a 3 second pause.
Note: When not in the Programming Menu, enter 984 at the keypad and press
the COMMAND key to display the remote options menu. This menu contains the
following options:
NBR RMT PICKUP
NUMBER - The panel allows you to enter into the keypad a phone number you want
the panel to dial. Enter any required prexes and area codes.
REMOTE - The panel dials the phone number programmed in Remote Phone Number.
PICKUP - The panel picks up the phone line as Remote Link™ calls in. The phone
must be ringing before selecting PICKUP.
5.9
DISARM NO YES
Remote Disarm
YES allows the panel to be disarmed remotely. NO disables remote disarming.