Installation guide

18 LCD Keypad Installation Guide
LCD Keypad Installation Guide 19
Accessing Keypad Diagnostics
If necessary, refer to Access the Installer Menu earlier in this document.
KPD KPD
OPT DIAG STOP
Keypad Diagnostics (KPD DIAG)
The Keypad Diagnostic option allows you to check
the display segments, keyboard backlighting and
test individual keys.
Press the Select key under KPD DIAG. The keypad
lights all display segments and illuminates the
keyboard in Red. In approximately one second
the display backlighting changes to Green. The
keypad alternates between these two states for
approximately two minutes. Press COMMAND at
any time to begin testing individual keys.
PRESS KEY TO
TEST
Test Individual Keys
The display changes to PRESS KEY TO TEST. This
option tests each key on the keyboard to ensure it
is operating properly. Press and hold each key for
about two seconds. The key number being held
appears in the display. Verify the correct number
displays before testing the next key.
Z1 OPEN Z2 OPEN
Z3 OPEN Z4 OPEN
Zone Test
(7070, 7073/7073A/7170/7173, 793 only)
This option allows the keypads to display the
current electrical status of the four protection
zones. The status is shown as OPEN, SHRT, or OKAY.
Note: The Zone Test displays on other keypads, but
is not operational.
INPUT WIEGAND
Input Wiegand
(7063/7063A, 7073/7073A/7163/7173,
693/793 only)
This option tests the internal and external reader
input from proximity credentials. The display
shows OKAY each time a good proximity read is
received.
Exiting the Installer Options
When done, press the COMMAND key once to return to the Installer Options
screen. Press the Select key under STOP to exit the Installer Options function.