Use and Care Manual

SLM447 System Quick Start Guide

Prior to connecting and operating the SLM447 Surveillance System, please read this quick start guide

carefully. Refer to the individual user’s manual included with the DVR for detailed operation.

Camera Setup and Connection

1) Remove all individual components and accessories from their packaging.

2) Using the included mounting hardware, install each of the cameras as desired. The (8) cameras supplied

are weatherproof and may be used indoor or out. Do NOT submerge these cameras. Be aware of any

existing utilities lines (electric, gas, water, etc) in the camera mounting area. Placed the cameras under an

eave or other protective area when mounting outdoors.

3) To connect the cameras to the DVR:

• Connect the video/power cable (supplied) to each camera. The BNC connection will supply

video to the DVR, the DC plug will supply power to the camera.

• Connect the BNC plug on the other end of the video/power cable to one of the video inputs on

the DVR.

• Connect the 2.1mm power jack and power supply as shown in the diagram. Do not attempt to power

other accessories or equipment not included in this system. If accessory items are added to the

system, use the power adapters that came with the accessory.

• Repeat for all cameras.

4) Connect the VIDEO OUT or the VGA video terminal on the DVR to the appropriate video in connection on

your monitor or TV.

5) Connect power to the DVR with the power supply as shown in the diagram.

6) Set up the DVR operation menu according to desired recording requirements.

THE MANUFACTURER DOES NOT ASSUME LIABILITY FOR ANY VIOLATION OF PRIVACY FROM ILLEGAL RECORDINGS OR MONITORING

MADE ON OR FROM THIS UNIT. THE USER/OWNER ASSUMES FULL LIABILITY FOR ANY AND ALL RECORDINGS MADE FROM THIS UNIT

IN A SECURITY OR SURVEILLANCE OPERATION OR IN ANY OTHER USE. THE MANUFACTURER IS NOT RESPONSIBLE FOR

RECORDINGS THAT VIOLATE LAWS OR THAT MAY PROVE OFFENSIVE OR TEND TO INCRIMINATE ANOTHER INDIVIDUAL. LOCAL, STATE,

AND FEDERAL LAWS MUST BE OBSERVED REGARDING ALL RECORDINGS.

Security Labs Customer Support Hotline

1-800-774-0284

15540 Herriman Blvd. Noblesville, IN 46060 www.security-labs.com

PAGE 1
SLM447 System Quick Start Guide Prior to connecting and operating the SLM447 Surveillance System, please read this quick start guide carefully. Refer to the individual user’s manual included with the DVR for detailed operation. Camera Setup and Connection 1) Remove all individual components and accessories from their packaging. 2) Using the included mounting hardware, install each of the cameras as desired. The (8) cameras supplied are weatherproof and may be used indoor or out.
PAGE 2
SLM447 System Connection Diagram SLC-1056 Cameras 8x CAMERA VIDEO OUT 12VDC POWER To: PWR SUPPLY Camera power breakout adapter (below) Monitor or TV (not included) NOTE: Use the DVR VIDEO OUT -or- the VGA VIDEO OUT for a connection to the monitor.