Full Product Manual

151
How to change built-in memory card
CAUTION: Please do not attempt to disassemble the camera while it is powered on.
Please disconnect the power and network cable before you proceed.
STEP 1:
Remove the sun visor by unscrewing the 2 top screws holding it into place and
unscrew the camera lens as shown in the images below.
STEP 2:
Remove the main board by unscrewing the 4 screws located on the perimeter of the
board. Please take note on the position of the cameras light sensor (circled in red).
It is very important that image sensor is facing downward when re-assembled or the
cameras image will be upside down.
STEP 3:
Note: The camera will not recognize Micro SD cards larger than 32 GB. Please make
sure that the card being used is properly formatted and does not exceed 32 GB.
Locate and eject the Micro SD card (circled in red) by gently pushing in on the
back of the card. Once ejected, insert the new Micro SD card and re-assemble the
camera.