User manual

ManualsBrandsSECUTECH ManualsSensorsLC 103 Contactless Tank Liquid Level Controller Meter

Dokument: 03 2012 LC 1 Short E 01

Security & Electronic Technology

Aumühlweg 3/1

A-2544 Leobersdorf – Austria

- Button = restart the Software

- Button = wake up device

go from one function to the other

- Button = Increment the flashing digit launch manual

measurement

Press for more than 3 seconds



1.1

Select the tank type

1 = rectangular 2 = horizontal cylindrical 3 = vertical cylindrical

1.2

Please refer to the dimension indications of your

Tank !!!

Volume : xxxx

Height : xxx

1.3

Enter the dimensions of tank type 2

Please refer to the dimension indications of your

Tank !!!

Volume : xxxx

Diameter : xxx

1.4

Power save mode

0 = Display OFF in sleeping mode

1 = Display ON in sleeping mode

1.5

Offset

Enter the distance from the sensor to the liquid in cm

(when the tank is full)

Offset = xx

Put the LC100 in the tank inlet

2.1

Start measurement

Press The display shows for 6 seconds the installed SW-

Version and makes then a first measurement ; from now on the

LC100 makes a measurement every 23 h 45 minutes !

2.2

Sleeping Mode

If the buttons are during 35” inactive, the LC100 goes into the

sleeping mode

Press >>> wake up !

Press >>> make measurement

(this measurement is not used for statistical data)

Press >>> wake up ! % & volume

Press >>> liters

Press >>> percentage

Press >>> empty volume in liters

Press >>> distance in cm

Press >>> average consumption “last 5 days”

Press >>> remaining days

Press >>> Error Codes

Error Codes

0 = LC100 OK

1 = Prgrm.-Error

2 = measurement incorrect

3 = distance unlogical to settings

4 = display overflow

Batt.low =„b“on default display