Instructions / Assembly

9
|
SEDONA ISlAND ASSEmbly INStructIONS
Locate the 4 transformer mounting screws (Part No. 2) and
the transformer/battery bracket. Mount the transformer
on the rear panel support frame near the rear panel outlet
using the pre-drilled holes provided. Install the side burner
battery bracket (not shown) below the transformer in the
same manner (see page 13).
SEDONA ISLAND ASSEMBLY INSTRUCTIONS
Step 6
Step 7
To simplify the installation, start by removing the drawers
and door. To remove the drawers, nd the black lever on
each side glide rail. One lever pushes up and the other one
down to release the drawer from the glides.
The access door simply lifts off of the hinge pins.
Place the storage system frame in the cutout and secure it
with 4 access door frame mounting brackets (Part No. 12
shown below, note the weld nut location), and 4 access
door frame mounting screws (Part No. 5). There are 2 on
each side.
Mounting the Transformer
Installing the Drawers and Door Storage System
These must be installed before setting the
counter top in place to allow access to
the storage system door frame mounting
bracket fasteners
With the help of an assistant or two, place the counter
top in place jiggle it a little until the walls slip into place,
and then secure the top with 2 wing nuts (Part No. 9) and
clamps (Part No. 11) located under the counter top, at the
front and rear.
Step 8
Install the Countertop
PART NO. 12