User's Manual

SHM-612v5
PTT Embedded
Bluetooth Headset
User Manual
SHM612 EarringEarhook User ManualBomm Mic
Bomm Mic
Manual
USB Charger
Cable
Volume
Button(Up)
Volume
Button(Down)
MFB
SPeaker
LED
Seecode Co., Ltd.
A-1107, Gwangmyeong Technopark,60, Haan-ro, Gwangmyeong-si, Gyeonggi-do, Korea (14322)
Tel : [phone] Fax: [phone]
Website : www.seecode.com E-mail : [e-mail]
REGULATORY
■ FCC Part 15
15.21
You are cautioned that changes or modifications not expressly approved
by the part responsible for compliance could void the user’s authority to
operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
1. this device may not cause interference and
2. this device must accept any interference, including interference that
may cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
■ Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Notice
This manual is published by Seecode Co., Ltd. without any warranty.
Improvements and changes to this manual necessitated by typographical
errors, inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Seecode Co., Ltd. at any time and
without notice. Such changes will be incorporated into new editions of this
manual. No part of this manual may be reproduced or transmitted in any
form or by any means, electronic or mechanical, including photocopying
and recording, for any purpose, without the express written permission of
Seecode Co., Ltd.
The material contained herein is subject to U.S. export approval. No export
or re-export is permitted without written approval from the U.S. Government.
Rated: EAR99 in accordance with U.S. Dept. of Commerce regulations
15CFR774, Export Administration Regulations. Repairs to this equipment
should be made only by an authorized service technician or facility
designated by the supplier. The opening of the device’s back cover or any
repairs, alterations or substitution of parts made to this equipment not
approved by the manufacturer will void the user’s authority to operate the
equipment in addition to the manufacturer’s warranty. This product conforms
to the European Union WEEE Directive 2012/19/EU. Do not dispose of this
product in a public landfill or open fire. Take it to a recycling center at the
end of its life.
Safety Conventions
The following conventions are used throughout this manual to alert the user
to general safety precautions that must be observed during all phases of
operation, service, and repair of this product. Failure to comply with these
precautions or with specific warning elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the product.
Seecode Co., Ltd assumes no liability for the customer’s failure to comply
with these standards.
Limited One Year Warranty
Seecode Co., Ltd, warrants this product to be free from defects in materials
and workmanship (subject to the terms set forth below) for a period of one
(1) year from the date of purchase (“Warranty Period”). During the Warranty
Period, Seecode Co., Ltd will repair or replace this product or any defective
parts (“Warranty Service”). If repair or replacement is not commercially
practicable or cannot be timely made, Seecode Co., Ltd may choose to
refund to you the purchase price paid for the affected product. Repair or
replacement under the terms of this warranty does not give right to any
extension or a new beginning of the period of warranty.
Claims under the Warranty
To obtain Warranty Service, please contact the Seecode Co., Ltd from which
you purchased this product for further information about customer support.
You will need to return this Product to the dealer or ship it to the dealer or to
Seecode Co., Ltd in either its original packaging or packaging affording an
equal degree of protection. You will bear the cost of shipping the product to
Seecode Co., Ltd. If the Product is covered by the warranty,
Seecode Co., Ltd will bear the cost of shipping product back to you after
the completion of service under this warranty. Return shipping will be
charged to you for products not covered by the warranty or requiring no
warranty repair.
Limitation of Warranty
This warranty is only valid for the original purchaser and will automatically
terminate prior to expiration if this product is sold or otherwise transferred to
another party.The warranty provided by Seecode Co.,Ltd. in this statement
applies only to products purchased for use, and not for resale.It does not
apply to open box purchases, which are sold “as is” and without any
warranty. Specifically exempt from warranty are limited-life consumable
components subject to normal wear and tear, such as microphone
windscreens, ear cushions, modular plugs, ear tips, decorative finishes,
batteries, and other accessories. This warranty is invalid if the factory-applied
serial number, date code label, or product label has been altered or
removed from this product.This Warranty does not cover cosmetic damage
or damage due to misuse, abuse, negligence, Acts of Nature, accident,
disassembling or modification of, or to any part of, the product. This Warranty
does not cover damage due to improper operation, maintenance or installation,
or attempted repair by anyone other than Seecode Co., Ltd which is authorized
to do Seecode Co., Ltd warranty work. Any unauthorized repairs will void this
warranty
WARNING
1. Prior to using this product follow these steps
• Before putting on the product, turn the volume control to its lowest level,
• Put the product on, and then
• Slowly adjust the volume control to a comfortable level.
2. During the use of this product
• Keep the volume at the lowest level possible and avoid using the product in
noisy environments where you may be inclined to turn up
the volume;
• If increased volume is necessary, adjust the volume control slowly; and
• If you experience discomfort or ringing in your ears, immediately discontinue
using the product and consult a physician.
With continued use at high volume, your ears may become accustomed to the
sound level, which may result in permanent damage to your hearing without any
noticeable discomfort.
Using the product while operating a motor vehicle, motorcycle, watercraft or
bicycle may be dangerous, and is illegal in some jurisdictions. Check your local
laws. Use caution while using your product when you are engaging in any
activity that requires your full attention.
While engaging in any such activity, removing the product from your ear area
or turning off your product will keep you from being distracted, so as to avoid
accident or injury.
© 2019 Seecode Co., Ltd. All rights reserved. SEECODE is a registered
trademark of Seecode Co., Ltd. All other trademarks included herein are the
property of their respective owners. The Bluetooth® word mark and logos are
owned by the Bluetooth SIG, Inc. Design and specifications subject to change
without notice.
Advantages
■ Compatible with both iOS and Android.
■ WBS (Wide Band Speech) supported
■ Battery save mode while using Smartphone PTT app
Thank you for purchasing the Seecode SHM612 PTT
Embedded Bluetooth Headset that can be used for
both Bluetooth Headset and Push To Talk Headset
as well. We hope you enjoy it together with your
PTT App of smartphone or mobile phone.
Specifications
■ Version: Bluetooth V4.1
■ Supported profile: HFP, HSP, A2DP, AVRCP, SPP, BLE
■ Talk time up to 6 hours
■ Standby time up to 150 hours
■ Built in 150mAh Rechargeable Li polymer battery
■ Within 2 hours charging time
■ Size: 50.5mm(L) x 18mm(W) x 12mm(H)
■ Weight: 11(g)
■ Operating range up to 10 meters (approx. 33 feet)
Charger
Socket
Getting started
Operating status
You should follow three steps before using your product
1. Charge your product
2. Activate Bluetooth on your mobile phone
(refer to the manual for your Mobile phone)
3. Pair your product to your mobile phone
The Seecode SHM612 is easy to operate.
The MFB (Multi-Function Button) on the product performs different
functions depending on how long you press it.
Event LED color Button
Duration
of Press
Led Pattern Beep Voice
Power ON MFB
flash Orange
1sec
Power ON
Power OFF V+ & V- 3 sec
flash Orange
1sec
Power OFF
Pairing mode MFB & V- 4 sec
blink
Red & Green
Pairing
While
connected
Green
While
disconnected
Red
Link loss
Double beep
during 10min
Reconnect
success
The H/S is
connected
Answer a call
Du-Du
End a call
Du
Warning Battery
Beep 5
Red
Green
MFB
MFB
1 sec
1 sec
1 sec