Datasheet

Grove – UART Wifi
Model no.: 113020010 Conrad article no.: 1408524
Introduction:
Grove - UART WiFi is a serial transceiver module featuring the ubiquitous ESP8266 IoT SoC. With integrated
TCP/IP protocol stack, this module lets your microcontroller interact with WiFi networks with only a few lines of
code. Each ESP8266 module comes pre-programmed with an AT command set firmware, meaning you can send
simple text commands to control the device. The SoC features integrated WEP, WPA/WPA2, TKIP, AES, and
WAPI engines, can act as an access point with DHCP, can join existing WiFi networks and has configurable MAC
and IP addresses.
Product Features:
• Grove 4-pin connector (RX,TX,VCC,GND)
• 802.11 b/g/n protocol (2.4GHz)
• WiFi Direct (P2P), soft-AP
• Supports three modes: AP, STA and AP+STA coexistence mode
• Integrated TCP/IP protocol stack
• LwIP (lightweight IP)
• Integrated low power 32-bit CPU could be reprogrammed as an application processor
• Integrated temperature sensor
• Serial UART Interface
• Multi-queue QoS management
• Wake up and transmit packets in < 2ms
• Metal shielding
• Onboard ceramic antenna
• Reset switch
Delivery Content:
• Module x 1 pc
• Grove 4 pin cable x 1 pc
More Details:
http://www.seeedstudio.com/wiki/Grove_-_UART_WiFi