User manual

Declaration of conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that
this product conforms to the fundamental requirements and other relevant regulations of the
1999/5/EC directive.
The declaration of conformity for this product is available at:
www.conrad.com
Maintenance and cleaning
The product does not require any maintenance and should never be disassembled for any
reason.
Prior to cleaning the product, switch the product off.
Use a clean, dry, soft cloth for cleaning. Do not use aggressive cleaning agents, as these can
cause discolouration. To prevent scratch marks, do not press too strongly on the surface when
cleaning. This could also damage the display.
Dust can easily be removed using a clean, long-haired brush and a vacuum cleaner.
Disposal
The product must not be disposed of in household waste!
Please dispose of the product at the end of its service life according to the current
statutory requirements.
Technical data
Observe the information in the manufacturer’s English operating instructions pro-
vided.
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
 Allrightsincludingtranslationreserved.Reproductionbyanymethod,e.g.photocopy,microlming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2015 by Conrad Electronic SE.
Switching on/off
Attention, important!
Before switching on the spectrum analyser, you must screw the antennas to the
antenna connectors (alternatively, use e.g. a 50 ohm terminating resistor).
If the spectrum analyser is switched on with the antennas missing (or if a 50 ohm
antenna is not connected), the receiver electronics can be damaged. Loss of war-
ranty!
The spectrum analyser with item no. 1386330 has 2x antenna connectors; an an-
tenna must be connected to both. The spectrum analyser with item no. 1386329 has
1x antenna connector.
Charging the battery
The integrated battery is generally discharged when the product is delivered. There-
fore,completelychargethebatterybeforerstuse.Thismaytakeseveralhours.
The battery can be charged via the USB port of a computer, a USB hub with own
power adapter or with a USB power adapter. Furthermore, you will need a suitable
USB cable (the spectrum analyser has a MiniUSB socket), which is not included in
the delivery.
a) Charging with PC
Switch the PC on.
Connect the spectrum analyser via a suitable USB cable with a free USB port in your computer.
Do not use USB ports of e.g. a keyboard as the current provided here is not suf-
cient.
The USB port must be able to supply a current of at least 500 mA.
Once the battery is charged, disconnect the spectrum analyser from the USB cable/PC.
b) Charging with USB hub
Connect the spectrum analyser via a suitable USB cable with a free USB port of your USB hub.
The USB port must be able to supply a current of at least 500 mA. Therefore, the
USB hub must have its own power adapter.
A USB hub without suitable power adapter cannot be used for charging the spect-
rum analyser.
Once the battery is charged, disconnect the spectrum analyser from the USB cable/USB hub.
c) Charging with USB power adapter
You will need a USB power adapter, which provides an output voltage of 5 V/DC and a current
of at least 500 mA.
Connect the spectrum analyser via a suitable USB cable with a free USB port of your USB
power adapter.
Once the battery is charged, disconnect the spectrum analyser from the USB cable/USB power
adapter.
Operation
Observe the information in the manufacturer’s English operating instructions provi-
ded.