Product Description

ManualsBrandsSeeed Studio ManualsElectronicsWio RP2040 Module

Wio rp2040 module Product description

1，Description

Seeedstudio Wio RP2040 Module is a small-sized 2.4GHz Wi-Fi module

support 802.11 b/g/n. It is based on the Raspberry Pi Foundation's RP2040

microcontroller. Easily create connected products making use of the Pi Pico

Micropython.

We take the pins of the RP2040 chip out, including GPIO/I2C/SPI/UARTs.

In addition, this module has an onboard PCB Antenna, no need to design the

antenna separately, so you can quickly deploy the module to your own board.

一，Key Features

1-1 Raspberry Pi RP2040 32-bit Cortex M0+ dual core, flexible clock running up

to 133Mhz

1-2 264KB of SRAM, and 2MB of on-board Flash memory

1-3 Support IEEE802.11 b/g/n

Summary of content (5 pages)

PAGE 1
Wio rp2040 module Product description 1，Description Seeedstudio Wio RP2040 Module is a small-sized 2.4GHz Wi-Fi module support 802.11 b/g/n. It is based on the Raspberry Pi Foundation's RP2040 microcontroller. Easily create connected products making use of the Pi Pico Micropython. We take the pins of the RP2040 chip out, including GPIO/I2C/SPI/UARTs. In addition, this module has an onboard PCB Antenna, no need to design the antenna separately, so you can quickly deploy the module to your own board.
PAGE 2
1-4 Support 2.4 ~ 2.4835 GHz 1-5 Support Ap & Station mode 1-6 Support for user-programmable GPIO control 1-8 Onboard PCB antenna 1-9 Small size 18.0x 28.2x 1.
PAGE 3
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
PAGE 4
Note: The module is limited to OEM installation only The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module FCC Radiation Exposure Statement This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
PAGE 5
Antenna information Antenna Type Antenna Gain PCB Antenna -8.62dBi Trace antenna designs: Not applicable.