Data Sheet

W M B T 0 1 ( - s , - s c ) D a t a s h e e t
35
/
36
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
System integrators must include the FCC ID on the end product.
2.2 List of applicable FCC rules：
The Seeed module is only FCC authorized (certified) for the transmitterspecific rule
parts, FCC 15.247. OEM manufacturer is responsible for compliance to all other FCC
rules that apply to the host.
2.3&2.6 Summarize the specific operational use conditions and FCC
Radio-Frequency Exposure & Approval Conditions：
Transmitting antenna(s) can only be installed at the display section of computer.
When this device is installed other than notebook computers, at least 20 cm
separation distance shall be maintained between the transmitting antenna(s) to the
body of user or nearby person.
2.4 Limited module procedures：
The module is an unrestricted module
2.5 Trace antenna designs：
The antenna(s) used for this transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter within a host device, except in
accordance with FCC multi-transmitter product procedures.
2.7 Antennas：
The module grantee is responsible for providing the documentation to the system
integrator on restrictions of use, for continuing compliance of the module including
the maximum antenna gain (3dBi),The antenna type is ceramic antenna.
2.8 Label and compliance information：
The regulatory label on the final system must include the statement:“Contains FCC
ID:FCC ID: Z4T-WMBT01”using electronic labeling method as documented in KDB
784748.
2.9 Information on test modes and additional testing requirements：
OEM manufacturer should perform additional verification/validation on supported
modes and is responsible for validation testing of module + host.
The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the
transmitter module except such device has implemented two-ways authentication
between moduleand the host system.
2.10 Additional testing, Part 15 Subpart B disclaimer：
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following