Data Sheet

W M B T 0 1 ( - s , - s c ) D a t a s h e e t
36
/
36
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
FCC INFORMATION (additional)
This device is intended only for OEM integrators under the following conditions: The
module must be installed in the host equipment such that 20 cm is maintained
between the antenna and users, and the transmitter module may not be co-located
with any other transmitter or antenna. The module shall be only used with the
internal antenna(s) that has been originally tested and certified with this module. As
long as 3 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
Module label:
FCC ID: Z4T-WMBT01
The final end product must be labeled in a visible area with the following: “Contains
FCC ID：Z4T-WMBT01 ”. Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user's manual of the end
product which integrates this module. The end user manual shall include all required
regulatory information/warning as show in this manual.
The module not applicable Limited module procedures. The module is a Single
module and complies with the requirement of FCC Part 15.2
The module has its own antenna, anddoesn'tneedahost's printed board
microstriptrace antenna etc, Not applicable Trace antenna designs