User's Manual
Table Of Contents
- 1. Introduction
- 2. Development Environment
- 2.1. Operating Systems
- 2.2. OpenWrt Introduction
- 2.3. Network Environment
- 2.4. System Configuration
- 2.4.1. Accessing Web UI
- 2.4.2. Accessing System Console
- 2.4.3. Using SSH (Secure Socket Shell)
- 2.4.4. Using Serial to USB Cable
- 2.4.5. Upgrading Firmware
- 2.4.6. Upgrading bootloader
- 2.4.7. Wi-Fi Reset
- 2.4.8. Factory Reset
- 2.4.9. Connecting LinkIt Smart 7688 To a network with Wi-Fi Access Point
- 2.4.10. Open a system console and enter the following commands to change LinkIt Smart 7688 to station mode ( For more information on system console, please see 2.4.1 “Accessing Web UI
- 2.4.11. Viewing System Information from the Web UI
- 2.5. Accessing the USB drive and the SD card
MediaTek LinkIt™ Smart 7688 User Manual
Figure 19 LinkIt Smart 7688 in Station mode connected to a Wi-Fi AP
Using Web UI
Open a browser and type in myLinkIt.local. Please see 2.4.1”Accessing Web UI”
if you’ve not signed in before.
1) Click Network button on upper right as shown in Figure 20
Figure 20 Change networking setting in Web UI
2) Select the station mode and click the Refresh button or
downward arrow on the right to find the AP to connect to.
After you’ve selected the AP, enter password if required.
Click Configure & Restart button to finish as shown in Figure
21.
© 2015, 2016 MediaTek Inc.
Page 33 of 38
This document contains information that is proprietary to MediaTek Inc.
Unauthorized reproduction or disclosure of this information in whole or in part is strictly prohibited.