Data Sheet

698
Atmel | SMART SAM D21 [DATASHEET]
Atmel-42181G–SAM-D21_Datasheet–09/2015
Table 30-13. Fault A Capture Action
z Bits 11:10 – CHSEL[1:0]: Fault A Capture Channel
These bits select the channel for capture operation triggered by recoverable Fault A, as defined in the table below.
Table 30-14. Fault A Capture Channel
z Bits 9:8 – HALT[1:0]: Fault A Halt Mode
These bits select the halt action for recoverable Fault A as defined in the table below.
Table 30-15. Fault A Halt Mode
z Bit 7 – RESTART: Fault A Restart
Setting this bit enables restart action for Fault A.
0: Fault A restart action is disabled.
1: Fault A restart action is enabled.
z Bits 6:5 – BLANK[1:0]: Fault A Blanking Mode
These bits, select the blanking start point for recoverable Fault A as defined in the table below.
CAPTURE[2:0] Name Description
0x0 DISABLE No capture
0x1 CAPT Capture on fault
0x2 CAPTMIN Minimum capture
0x3 CAPTMAX Maximum capture
0x4 LOCMIN Minimum local detection
0x5 LOCMAX Maximum local detection
0x6 DERIV0 Minimum and maximum local detection
0x7 Reserved
CHSEL[1:0] Name Description
0x0 CC0 Capture value stored in channel 0
0x1 CC1 Capture value stored in channel 1
0x2 CC2 Capture value stored in channel 2
0x3 CC3 Capture value stored in channel 3
HALT[1:0] Name Description
0x0 DISABLE Halt action disabled
0x1 HW Hardware halt action
0x2 SW Software halt action
0x3 NR Non-recoverable fault