User Guide
Table Of Contents
- Table of Contents
- 1 Product Introduction
- 2 Quick Start
- 3 Device Installation
- 4 Network Configuration
- 5 SenseCAP Portal
- 6 SenseCAP App Instructions
- 7 API Instruction
User Guide (Tech Document)
© 2008-2019 Seeed Technology Co., Ltd. All rights reserved. www.seeed.cc
13 / 50
⚫ Installing on a pole (Use the Ferrules and Aluminum pieces)
Firstly, use M5 self-drilling screws (included in the package) to fasten the 2 Aluminum pieces onto the
gateway. And then use ferrules to fasten the gateway onto the pole. The recommended pole diameter is
76mm.
Note: If the pole is made of metal, the antenna should be pulled higher than the metallic part of the
pole, or the communication signal will have interfered.
⚫ Installing on the Wall
Firstly, use M5 self-drilling screws (included) to fasten the 4 brackets onto the enclosure of the gateway
(refer to the image below for directions). And then fasten the gateway onto the wall with screws.