User Guide
Table Of Contents
- Table of Contents
- 1 Product Introduction
- 2 Quick Start
- 3 Device Installation
- 4 Network Configuration
- 5 SenseCAP Portal
- 6 SenseCAP App Instructions
- 7 API Instruction
User Guide (Tech Document)
© 2008-2019 Seeed Technology Co., Ltd. All rights reserved. www.seeed.cc
26 / 50
Gateway Network Configuration
Make sure all antennas are correctly installed before powering on the gateway. Please note the device
should be POWERED OFF when installing the antenna, or the antenna circuits might be damaged.
4.1.1 Connecting to Ethernet
Please refer to the previous chapter to connect the gateway to the Ethernet cable and power cable.
Power on the gateway and wait for 1~2 minutes. When the light is on, it indicates that the gateway is
connected to the network successfully.
Please see below for different indicator statuses.