User Manual

User Manual

11 / 37

Connect to a Standard LoRaWAN Gateway

SenseCAP Sensor Nodes support standard LoRaWAN 1.0.2 protocol, making it possible to connect to

standard LoRaWAN gateways and servers.

3.3.1 Power On

The power switch is hidden inside the device. Open the device and turn on the power before installing the

sensors. Here is the step-by-step instruction:

1) Loosen the Sensor Probe by turning the cap counterclockwise. Use the white cap opener to make this

process easier. The image below uses TH Sensor as an example and applies to all other SenseCAP

sensors.

2) After opening the device, turn the switch to “ON”, and the LED on the lower right corner will flash,

indicating that the power is on. Wait for about 10 seconds, then the LED will flash quickly for 2 seconds,

indicating that the device is connected to the network.