Owner's Manual

19 |
ILL1632-A
ILL1596-C
CONTROLLER OR SYSTEM RESET
It is possible to reset the whole system (including all connected components)
or the MagIQtouch Controller only.
Use a pin or paperclip to press and hold the reset button located
at the back.
This will cause the following screen to appear:
Note! RESET WALL CONTROLLER ONLY
This option should only be selected if the wall controller connected was
previously used in another installation.
RESET WHOLE SYSTEM
Resetting the whole system will set all components connected to the wall
controller to default factory settings. When a system is reset it will be
required to go through ‘System Installation Wizard’ again from the start,
including pairing with the wireless wall controller to the wireless receiver.