Operation Manual

GENERAL OPERATION
GENERAL OPERATION
1. S elect the source by setting the FUNC TIO N S ELEC TO R to RA DIO , O FF or C D.
2. S et the desired volume level using the V O LUME C O NTRO L.
3. To turn off the unit, set the FUNC TIO N S ELE C TO R to O FF.
RA DIO R EC EPTIO N
1. Adjust FUNCTION SELECTOR to RADIO.
2. P osition the BA ND S ELEC TO R on the desired band: AM, FM o r FM S T.
3. Turn the TUNING K NO B to search for the desired station.
NO TE: The FM stereo indicator comes on if the BA ND SELEC TO R is set on FM stereo and you have tuned
the radio to an FM stereo station.
4. Adjust V O LUME C O NTRO L for the desired volume level.
5. When you have finished listening to the radio, position the FUNC TIO N SELEC TO R to O FF to turn the
unit off.
Notes: As automatic tuning depends on the signal strength of the transmitters, weak transmitters are
sometimes skepped. In such a case, tuner manually to find the weaker transmitters. O n the other hand,
with a very strong signal, the tuner may stop before it reaches the optimum setting. Tune manually for the
best reception.
Helpful hints:
To improve radio reception
To listen to the FM radio, extend the telescopic antenna and orient it for optimum reception. Reduce
the length of the antenna if the signal is too strong (if you are v ery near the transmitter, for example).
As the unit is equipped with a built-in antenna, the telescopic antenna does not have to be used to
listen to AM stations. Move the e ntire unit to orient the built-in antenna.
STEREO H EADPHONE JACK
Plug stereo headphones (not included), equipped with a 3 .5mm mini-plug, into the PHO NES jack for private
listening, without disturbing those a round you.
Reduce the V O LUME to a low level before putting on the headphones. Yo u can then adjust the V O LUME
progressively to a c omfortable level.
No ted: The speakers will be muted when headphones are connected to the set.