Operation Manual

9
7- Connection between different input signals
A) Connect with PC signal
1. Connect the signal cable from the monitor output socket of the
PERSONAL COMPUTER to the PC input socket of the set.
2.. Press the TV/AV button to select PC.-RGB
3. Switch on the PC, and the PC screen appears on the set.
The set can be operated as the PC monitor.
Connection steps：
：：
：
l Read the user guide supplied with your computer and ensure that it has a VGA connector;
l Make sure that the power of the LCD-TV and the PC are off;
l Connect a D type 15-pin VGA interface cable (not supplied) to the VGA video interface connector on
the PC. Then connect the other end to the VGA video interface connector on the back of the
LCD-TV. Tighten the screws on the VGA connectors once they are firmly connected;
l Turn on the power of the LCD-TV first, and then turn on the power of the PC;
l Press the INPUT button to set the video input mode of the LCD-TV to “PC”;
l Our LCD-TV can support the resolutions list in table 2. If the resolution you want is not listed, the
LCD-TV may not display the image properly,
Table 2
Resolution
640x480 800x600 1024x768
Horizontal frequency（
（（
（
KHz）
））
）
31.5-37.5 37.9-46.9 48.4-60
Vertical frequency（
（（
（Hz
）
））
）
60-75 60-75 60-75