Operation Manual

UK-4
OPERATING THE UNIT
POWER/STANDBY
When you first plug the unit into the AC outlet ,the unit will be in standby mode. You can press the
STANDBY/ON button on the unit or on the remote control to switch the unit ON or OFF. Pull the AC
plug out of the wall socket if you want to switch of
f completely.
1. Press the STANDBY/ON button on the unit or on the remote control to switch the unit on.
2. Select the sound source (CD/MP3, AUX , or RADIO) by sliding FUNCTION switch to the correct
position. Adjust the volume with the VOLUME (UP or DOWN) button.
3. Press the ST
ANDBY/ON button again to turn off the unit.
During in the STANDBY mode.
1. Press and hold the PROGRAM/CLOCK-ADJ. button until the time displays will change to
24-hour digit and flash.
2. Press the SKIP/SEARCH(UP or DOWN) button to adjust 12-hour or 24-hour digit.
3. Press the PROGRAM/CLOCK-ADJ. button again, the HOUR digit will flash on the display
,
press the SKIP/SEARCH(UP or DOWN) button to adjust HOUR digit.
4. Press the PROGRAM/CLOCK-ADJ.button once more, the MINUTE digit will flash on the display,
5. Press the PROGRAM/CLOCK-ADJ. button again to confirm the time.
6. Each enable state as shown above will be cleared if the key is not pushed in10 seconds.
CLOCK SETTING
TO SET SLEEP FUNCTION(on the remote)
To fall asleep to music, press the button on the remote control for adjust the Radio, CD, USB and
Card player's sleep function from 90 to 10 minutes of music before shutting off automatically
NORMAL
RADIO OPERATION
Slide the FUNCTION switch to the radio mode on the unit ,you can select the radio operation.
Slide switch
Slide switch
MONO/ STEREO SELECT
You can use this function only in FM mode.
1. Press the STOP/FM MONO/ST. button on the unit or on the remote control. the " " indicator
will appear on the display, you can receive FM stereo transmission .
2. Press the STOP/FM MONO/ST
. Button to MONO position, the FM STEREO indicator will turn off
to FM MONO broadcast stations.
AM
the BAND to select AM mode. Turn the TUNING control to select the required station.
For operation on AM the set control a built-in ferrite aerial which is directional. Therefore, the set
should be positioned for the best signal strength.
FM
the BAND to select FM mode. switch. Turn the TUNING control to select the required
station. The " “ indicator will show a stereo broadcast is being received. Fully extend the FM
antenna and adjust its direction for best FM reception.
FM