Operation Manual

UK-12
The radio will start automatically scanning for strong radio signals. The TUNER
Display shows the frequency in MHz for FM,
The tuner will stop scanning when it finds a strong signal.
Repeat this process until the desired station is found.
Notes: As automatic tuning depends on the signal strength of the transmitters, weak
transmitters are sometimes skipped. In such a case, tuner manually to find the weaker
transmitters.
On the other hand, with a very strong signal, the tuner may stop before it reaches the
optimum setting. Tune manually for the best reception.
Storing Stations
This unit allows you to store the frequencies of up to 30 radio stations (30xFM)in the
memory;
First tune into the station you want to store using one of the methods above.
Then press the MEM/C-ADJ. button(16) on the unit or on the remote control(5).
Press PRESET/FOLDER-UP or PRESET/FOLDER-DN Buttons on the unit (12) or
on the remote control (15,16) to select the desired channel memory and press the
MEM/C-ADJ. button within 5 seconds to store it.
To reprogram a preset station repeat the procedure above.
Selecting a preset station
To select a preset station, press the PRESET/FOLDER-UP or PRESET/FOLDER-DN
Buttons on the unit(11,12) or on the remote control(15,16until the desired preset
program is displayed.
FM Stereo Reception
When an FM signal is tuned in, the (((ST.))) indicator will appear in the display.
In case of noisy reception, if you push the ID3/FMMONO-STEREO button (17) to
FM MONO position, the FM STEREO indicator will turn off & switch to MONO FM
status
Antenna
For FM reception there is a wire antenna (24) at the rear of the unit. Extend it for best
reception.
CD/MP3/WMA OPERATION
Loading and Unloading Compact Discs