Owner`s manual

Take out the 2 Hexagon Nuts and remove the Pillow Block and Torision Spring.

When removing the Pillow

Block, be sure to remove the

straight from the Shaft. Remov-

ing it in an inclined direction

can make work more difficult

and cause injury hazard. Also,

this can cause the oppisite side

Shaft to be subject to an exces-

sive load and cause Shaft

damage.

Reassemble by using the

oppisite procedure.

Replace the Spring. Ensure

that the longer part of the

Spring is positioned to the

Control Panel’s center side.