Installation Guide

Please read the instructions carefully. Installation of this product should be attempted only by individuals skilled in the use

of the tools and equipment necessary for installation. Protect yourself and all persons and property during installation. If you

have any doubt concerning your competence or expertise, consult a qualiﬁed expert to perform the installation. Segal Lock

Company assumes no responsibility or obligation for the failure of an architect, contractor, installer, or building owner to

comply with all applicable laws, building codes and requirements and adequate safety precautions.

THE FOLLOWING FORMATS ARE USED FOR SAFETY NOTES IN THESE INSTRUCTIONS

This type of warning note is to indicate that

failure to follow the indicated instructions may

result in severe injury or death.

This type of warning note is used to indicate that

failure to follow the indicated instructions may

result in failure of or damage to the product and

may cause serious injury.

This type of warning note is used to indicate that

failure to follow the indicated instructions may

result in failure of or damage to the product.

Window / Child Guard Installation Instructions

BEFORE PROCEEDING, READ THE INSTRUCTIONS FULLY!

IMPORTANT SAFETY NOTES

Meets New York City Department of

Health Requirements,

Approval Code - HDWG #04-09-2010

Do Not Use This Window Guard For

Slider Style or Casement Windows.

• Before installation, contact your local building code department or ﬁre department for speciﬁc

codes related to this installation.

• Make sure that your window frame is in good condition, and can accept the fasteners used in

this installation.

• Use only the approved fasteners supplied with this product.

• Fasteners should always be ﬁrmly anchored to a solid stud or window frame material for

maximum safety. Never anchor fasteners to decorative molding.

• Always use the provided stops or “L” brackets to limit the inside sash from opening more than

4" higher than the top horizontal member. (This is a building code requirement. )

• This window guard is intended to protect against potential window falls by children age 10 &

under.

• Window guards are designed to be a deterrent to accidental window falls. This product is not

intended as a substitute for proper adult supervision.

• Window guards are not meant for, and should never be used as protection against intruders.

PAGE 1
Meets New York City Department of Health Requirements, Approval Code - HDWG #04-09-2010 Window / Child Guard Installation Instructions BEFORE PROCEEDING, READ THE INSTRUCTIONS FULLY! IMPORTANT SAFETY NOTES Please read the instructions carefully. Installation of this product should be attempted only by individuals skilled in the use of the tools and equipment necessary for installation. Protect yourself and all persons and property during installation.
PAGE 2
Non-Egress Style Installation Instructions Single & Double Hung Windows Tools Required for Installation: Tape Measure Screwdriver Drill Motor 1/8” or 9/64” Twist Drill Parts Included: Window Guard, 1 Hardware Pack (8 Screws, 2 ‘L’ Brackets, Instructions) Make sure that the size of your window does not exceed the stated size range that can be found on your window guard product label. Be sure there is no more than a 4 inch opening anywhere in the guarded area.