2-WAY REMOTE STARTING SYSTEM WITH 1 BUTTONS FOR AUTOMATIC TRANSMISSION RED301-2WAY / ANT-2WDSS User Guide For Key This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
WARNING It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. 1. When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in “Park” in order to avoid accidents upon remote starting. (Note: Make sure that the automatic vehicle cannot start in “Drive”.) 2. It is the user’s responsibility to ensure that the remote starter is disabled or put into valet mode before servicing.
Usingg the remotee control Descripption of Remotte Appearance Lock, Unlock and a Remote Lock, Unlocck and Remote Starting icon is s displaying with Starting icon n is displaying with One LED color. Two LED co olor. Loc ck/Unlock Note: Press the button 1 time on the rem mote control transmittter to lock the veh hicle. Press the butto on 2 times to START/STOP: unlock the driver’s door, 2 additional Note : Remo ote Engine Start - tim mes to unlock all doorrs.
Vehicle Presets Heater When leaving the vehicle it is recommended to preset the accessory controls in preparation for the Next remote start. Settings for the blower motor(fan),front and rear (if equipped),should not be left on HIGH. It is recommended to leave the settings on LOW or MEDIUM instead. Windshield Wipers, Headlights Certain vehicles require the windshield wipers and headlights circuits to become energized while running under remote start.
Note: LED D icon of 2way tra ansmitter indicates s firstly blue colorr and then change e to “RED” color when you press an ny button. In this case, it’s time to change CR2025 ba attery ne ewly Descripption of Antennna Appearance e 2Way Antenna Antenna Harness Note: Usse the power of the e antenna car batttery 12volts.
Remote-Starting your Ve ehicle Remote-Starting For the 2 2-way remote: 1. Press tthe butto on one time. The remote will beep o once and display tthe Lock icon. The en, press the button within 2 seconds. The remote r will beep once o and display th he KEY icon. 2. 5 seco onds later, the rem mote will activate starter. s The Key iccon will be shown with 3 different tones of beeping th hen the LED Icon will w be scrolled.. For the 1 1-way remote: 1.
2. Press tthe brake pedal to o disengage the re emote starter unitt. With the vehicle e key is in the IGNITION ON positio on, press the brake e pedal or wait 30 0 seconds for the vehicle v to turn to ready status to drive e. Note: In rremote engine sta art status, engine will w be deactivated according to following conditions. - Open th he door and 30 se econds is passed. - Press brake pedal withou ut key is in IGNITION ON position.
Valet/Serrvice Mode For REM MOTE Start KEY F Fob Valet/Serrvice mode is used d to prevent the system from unexp pectedly starting tthe engine while being b serviced. When you ur vehicle is in Va alet Mode, the rem mote starter functio onalities are disab bled. If the vehicle e needs to be serv viced, or if you park it indoors, the Valet V Mode will pre event the engine fro om being remote--started accidenta ally.
Changing any one of the settings may affect the operation of your Remote Car Starter. Engine Run Time setting Option Setting Condition Disarm the vehicle with remote control transmitter.(Unlock) Driver s door must be physically Open, Engine Stop, Ignition ON, Trunk Open and Hood Open. Option Setting Instruction - Under option setting condition, press button for 2 seconds. Light and Horn of vehicle will activate according to Engine Run Time option.
- When re eplacing the main controller installe ed in the vehicle. - When a adding or changing g the remote upon n user’s need. 2. Pairing g procedure R RS Fob X1 1 5X X 1) Open d driver’s door and trunk. 2) Insert tthe key into the ig gnition. Turn the key from OFF to O ON position 5 times within 5 seconds. 3) After step 2), within 5 se econds, Press buttton on the 1st Re emote Start Fob 1 time.
-The condition of the batteries in the transmitter. -The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers, etc). -Metal in the area of the vehicle of transmitter. This includes the vehicle itself. -The shape of the vehicle can affect range as well. Vans in general have greater interference. The shape of the roof and A-pillars causes considerable radio-frequency interference. Demonstrate to users that the best range is facing the vehicle's front.
