User's Manual
11 Page
Page 10
l@b@s
You can turn this feature on and off by pressing the and buttons for more than 2 seconds.
The vehicle will start at the same time even if the battery voltage falls below the set value. If Time start was already set in
advance and low battery start is set, Time start is automatically cancelled.
Note: If the vehicle’s battery voltage is too low, Time start and Low battery start will not be activated.
t@s
You can turn this feature on and off by pressing the and buttons for a 1/2 second.
If Time start is set, the vehicle will start by itself
at the preset time every 24 hours.
If low battery start was already set in advance and time start is set, low battery start is automatically cancelled.
r@d@l
To UNLOCK the doors and DISARM the system:
Tap the button for 1/2 second.
(2-way) The remote will beep twice and display the icon to confirm unlocking of the doors.
Note: In Arming status,
the remote detects the door unlocking.
To LOCK the doors and ARM the system:
Tap the button for 1/2 seconds.
(2-way) The remote will beep once and display the icon to confirm locking of the doors.
Note:
If you press the unlock button once, the vehicle is disarmed and only the driver side door is unlocked. If you press the
unlock button again within 5 secondes, all doors will unlock.
e@r@t
Your Remote Car Starter can be programmed to run the engine for 3, 8 or 15 minutes (3 minutes by default)
Option Seting Function
#1 Feature
Default (I) Optional (II) Optional (III)
1-3 Remote Start Run time 3 Min 8 Min 15 Min
Setting
Option Setting Condition : Driver's door must be physically open. + Key out of the Vehicle. + Ignition OFF.
1. For example, option 1-3 Remote Start Runtime
1) Press button for 2 seconds simultaneously
Vehicle chirps 1 time and light flashes 1 time -> ready to enter option change mode.(Within 3-4 seconds)
2) Option Change Mode
Select the option number and tap button as much as the option number you selected
For Remote Start Run option(1-3), Tap button three(3) times as follows:
Tap button, vehicle chirps 1 time & light flashing 1 time -> This is 1st time.
Tap button, vehicle chirps 1 time & light flashing 1 time -> This is 2nd time.
Tap button, vehicle chirps 1 time & light flashing 1 time -> This is 3rd time.
You can go to the next stage only after you confirm the chirping & flashing every time. -> wait 4 seconds
3) After 4 seconds, vehicle will chirp 3 times & light flashing 3 times simultaneously
-> This reaction is confirming the user selected option # 1-3 "Remote Start Runtime"
4) Select the running time:
If you want to set at "8 Min - Option(II)", Tap button. Vehicle finally chirps 2 times & light flashing 2 times
-> This is confirming the user selected default option(II)
If you want to set at "15 Min - Option(III)", Tap button. Vehicle finally chirps 3 times & light flashing 3 times
-> This is confirming the user selected default option(III)
2. To RESET to Original state Default(l)
Repeat Above Step 1 & 2, then Press the button three(3) times, option is reset to Default(l)
Remote Starter Features