t @o@c i t @o@c T w@c T q@r U v @m r @m @M@b @r p@ @c@Hlcd@r @oI Rw@r @b@f Qw@r @b@f By Firstech, LLC 2 U V V W Y g @s @f s @c r @c a @l@O@a@@u@O@d p @l@O@a a@t@r @s@f m@t@r @s@f@Hr @m I a
Introduction Thank you for purchasing a Firstech system for your vehicle. In order to truly enjoy the benefits of this system, we recommend that you thoroughly review the following manual. Please note that this manual applies to the 2 Way - 4 Button Liquid Crystal Display Remotes, regardless of whether you purchased the alarm only, starter only or alarm/starter combination. This manual also supports your 1 Way Fiancé remotes that may be included with your system.
Quick Reference r @m Mb @r The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery. Two Way Remotes: First, release the battery cover lock located on the back of the remote. Once the lock is released, gently slide the battery cover off to expose the battery. With the exception of the 2WSSR-PRO (Uses 1 AA battery) all Firstech 2 Way remotes require one AAA battery.
Quick Reference Quick Reference R@w@r @b@f Button Duration AdditionalProgramming Required Function / Description II + IV III + IV By Firstech, LLC Button Duration AdditionalProgramming Function / Description Required 0.5 seconds yes Drive lock. Activates ignition controlled door locks 0.5 seconds no 2.5 seconds no Option programming menu 2. For use during installation 3.5 seconds no Panic/vehicle locater (flashes vehicle’s parking lights and sounds siren and horn) 0.
Quick Reference Remote LCD(liquid crystal display) Diagram and icons Your remote pager will indicate the status of your vehicle while in range. The unique LCD design will visually display such icons as lock/unlock status, remote start confirmation and remaining run-time, impact/shock notification, battery voltage, temperature display and much more. Q@w@r @b@f Button Duration Additional Programming Function / Description Required 0.5 seconds yes Drive lock.
Remote LCD(liquid crystal display) Diagram and icons c@iM Remote LCD(liquid crystal display) Diagram and icons s @iM Engine Running This icon will be displayed while the vehicle is running after it has been remote started. Lock/Arm - Unlock/Disarm This icon indicates whether the system is locked/armed or unlocked/disarmed. While armed, the system will monitor the doors, trunk, hood, shock sensor, and aux inputs.
Impact This icon will be displayed if an impact to the vehicle is detected while the system is armed. The remote will beep rapidly while displaying this icon if the impact is hard; this means that the alarm was triggered. If it beeps slowly while displaying this icon, that means that the impact was soft and that the alarm simply gave four warning chirps. Door This icon will be displayed if the door is opened while the system is armed. The remote will beep rapidly while displaying this icon.
General System Functions The remote transmitter functions have been predetermined and programmed from the factory. The four button configuration allows for many functions to be performed through a series of tapping, holding and / or multiple presses of buttons. Sending Commands When in range, and a command has been sent, the remote pager backlight will illuminate, the remote will beep and the appropriate icon will be displayed.
