User's Manual

12
Hood
This icon will be displayed if the hood is opened while the system is armed. The remote will beep rapidly while displaying this icon. This means
that the alarm was triggered. If this icon appears while trying to remote-start the vehicle, it means that the vehicle will not start because the hood
is open.
Impact
This icon will be displayed if an impact to the vehicle is detected while the system is armed. The remote will beep rapidly while displaying this
icon if the impact is hard; this means that the alarm was triggered. If it beeps slowly while displaying this icon, that means that the impact was
soft and that the alarm simply gave four warning chirps.
Door
This icon will be displayed if the door is opened while the system is armed. The remote will beep rapidly while displaying this icon. This means
that the alarm was triggered. If this icon appears while trying to remote-start the vehicle, it means that the vehicle will not start because the hood
is open.
Trunk
This icon will be displayed if the trunk is opened while the system is armed. The remote will beep rapidly while displaying this icon. This means
that the alarm was triggered. If this icon appears while trying to remote-start the vehicle, it means that the vehicle will not start because the trunk
is open.
Car Call
This icon will be displayed while someone is attempting to contact you using the RPS sensor. To trigger the RPS sensor, you must knock on the
windshield where the sensor is located. Something that creates a higher pitch, like a key, is better suited to trigger the RPS.
Advanced Icons – These icons are used on alarm only or alarm/starter systems that use this remote.
Passive Mode
This icon will be displayed if Passive mode is currently active. Passive mode will automatically arm the system 30 seconds after the last door is
closed or 30 seconds after the system was disarmed if no door was opened. This mode is ignored while the ignition is on with the key.
Drive Lock
This icon will be displayed if Drive Lock mode is currently active. Drive Lock mode will lock the doors automatically if the ignition is on and the
brake is pressed or if the ignition is on and the engine exceeds the idle RPM multiplied by 2, depending on the options set by the installer. The
doors will be unlocked when the ignition is turned off. In a manual transmission vehicle the doors will unlock when the emergency brake is set.
Turbo Mode
This icon will be displayed if Turbo mode is currently active. While Turbo mode is active, the vehicle will remain running for a preset time after the
ignition has shut down if the emergency brake is set before the ignition is turned off.
2
nd
Car Mode
This will be displayed while you are in 2
nd
Car mode. 2
nd
Car mode allows you to control another vehicle with the same system installed in it. The
remote needs to be coded to the other vehicle in 2
nd
Car mode for this feature to work.
Vibration
This icon will be displayed if the remote is set to vibrate only. While the remote is set to vibrate only the remote will not beep, even if the alarm is
triggered. The remote will still vibrate in this mode.
Alarm Clock
This icon will be displayed if the Alarm Clock function is turned on. When the clock reaches the preset time, the remote will beep and flash the
alarm clock icon. Press button IV for 0.5 sec. to silence the remote.