User's Manual
4
1. I for 0.5 Seconds – Lock/Unlock – Tapping this button for a split second will lock/arm and unlock/disarm your CompuStar system.
2. I for 2.5 Seconds – Auto Mode is activated (Auto Icon shows up) or Remote Start Run Time is reset during remote start.
1) Auto Mode: There are 3 different Auto Modes.
A. Auto Mode 1 – Low Power, Auto Icon On. When holding button I for 2.5 seconds, Auto Mode engages on the low power setting. Once you go out of range of
your vehicle the
system will automatically lock and arm. Once you come back into range, your system will automatically unlock and disarm your CompuStar.
B.. Auto Mode 2 – High Power, Auto Icon flash. This will increase the range of auto arms and disarms.
C. Auto Mode 3 – High Power, Auto icon flash rapidly. Same as 2, except:
If you remain on the border of range between your remote and vehicle and your CompuStar automatically locks and unlocks, a failsafe will engage. Once your
system Auto locks and unlocks twice in a 2 minute period then Auto Mode will cancel. You will have to tap button I to unlock your CompuStar and turn Auto
Mode back on.
When you hold button I for a fourth time the Auto icon will turn off and Auto Mode is disabled.
2) If your vehicle is running with remote start, you can Reset Remote Start Run time by pressing button I for 2.5 seconds.
3. Tapping button II or III will activate Aux 1 or Aux 2, which can be used to activate side doors, window modules, etc.
By default, these buttons can only be activated as Secure Aux to prevent accident activation. Click IV before you activate II or III. This can be changed – ask your
installer. You may want to remove Secure Aux if you connect Aux to open side doors.
4. Button IV (0.5 seconds) has 3 functions:
1) Car Check - Has three stages. Press button IV for 0.5 sec again to advance to the next stage. (1)Vehicle Temperature, (2)Vehicle Battery Voltage, (3)Remote
Battery Voltage.
2) Secure Aux – Secure Aux protects you from accidentally activating Aux 1 or Aux 2. It is designed so you do not accidentally roll down your windows or pop
your doors.
3) Memory for remote settings and time clock – Tap IV before you remove the battery. When you insert a battery back, the remote settings and time clock will be
restored
5. Button IV (2.5 Seconds) – Button Lock – Holding down button IV for 2.5 seconds will activate the button locking feature on your remote. This is designed so you
do not
accidentally hit any buttons while the remote is in your pocket.
6. Button IV (4 Seconds) – Panic Mode – Holding down button IV for 4 seconds will panic the siren. You can turn panic mode off by tapping button I. This Panic
mode will also activate the Anti-Jack mode. The Anti-Jack mode will require additional installation.
7. Button I+II – Siren On/Off – Tapping these two buttons at the same time will mute the siren chirps during arm/lock and disarm/unlock. This feature will also mute
the siren
when the siren is set to 20 chirp silent siren
8. There are three different ways to enter Valet mode.
1) I+III together for a half second while Ignition is on. Your installer can change the setting so that you do not have to turn ignition on.
2) Ignition On and Off for 5 times with key
3) Secure Valet – Consult your installer for this feature. If your installer turns on Secure Valet option, you can put the system into Valet mode with the valet/LED
button by
following steps 3-5 below. You can change the valet code numbers as follows:
A. Your installer must program Option 3-10 to setting 3.
B. Turn key to the ignition on position.