User's Manual

5
C. Hold down valet switch for 1.5 seconds. The LED on the switch will begin to flash rapidly.
D. Tap the button on the switch to enter first number of 2-digit code. LED will flash the first number slowly.
E. Once the LED begins flashing rapidly tap the button on the switch to enter the second number.
F. Turn ignition off and Valet Switch is now programmed.
G. To enter valet mode follow steps 3 to 5
H. If the RPS unlock code (explained later in this manual) is already set and you set the Valet Switch then it overwrites the first two digits of the RPS code
9. Button I+III (2.5 Seconds) – When you hold these two buttons together for 2.5 seconds you can disable your shock sensor. This also disables any other added
sensors such as radar, proximity or tilt sensors.
10. Button I+IV – Drive Lock On/Off – Tapping buttons I+IV at the same time turns on the “Drive Lock” feature on your system. Your CompuStar dealer must also
set this option in the option menu. This feature locks your vehicle when you turn the ignition on and press the foot brake or accelerate. The CompuStar will unlock
your vehicle when you turn the key off or set the emergency brake. (manual transmissions only)
11. Button II+III – Passive Arming On/Off – Tapping buttons II+III at the same time turns Passive mode on. With passive mode on, your vehicle will lock and arm
30 seconds after the door is opened and closed. The parking lights will flash and/or siren will chirp every 10 seconds up to 30.
12. Remote Options Programming
Button II+III (2.5 Seconds) – Holding buttons II and III for 2.5 seconds will put the remote into and take out of the Remote Option Menu. There are 7 different
options in the Remote Option Menu that can be set. To toggle through the menu just tap button IV to move down each option. Tap button III to move up each
option in the menu.
(Note: The Remote Option Menu will flash certain icons to show which section of the menu you are in. Please refer to the table below.)
Setting Remote Options
Button Duration Effect
II+III 2.5 sec Enters/exits Remote Programming mode.
IV 0.5 sec Moves forward through the options.
III 0.5 sec Moves backward through the options.
I 0.5 sec
Adjusts hour on time based options or turns options
on/off.
II 0.5 sec Adjusts minutes on time based options.
Flashing Icon Setting Being Adjusted
Clock Time
Clock/Timer/Exhaust Automatic Start Time
Clock/Timer/Alarm
Clock
Alarm Clock Time
Alarm Clock Alarm Clock On/Off
Car Call Car Call using RPS On/Off
Vibration Vibration mode On/Off
°F or °C Temperature displayed in Fahrenheit or Celsius