User's Manual

9
IV. Additional Features
1. RPS UNLOCK
The RPS must be programmed in order to have the coded unlock and disarm feature on your CompuStar. This can be used in the event you lose your remote or
destroy it. This programming can only be done if the CompuStar is disarmed.
1) RPS default code is 3,3,0,0
2) Leave driver’s door open. Turn key to the ignition on position.
3) Knock on RPS a total of 10 times. LED will begin to flash rapidly on RPS
4) Enter the first number by knocking on the RPS the amount of times for number 1. The LED will flash the first number slowly.
5) Once the LED begins flashing rapidly knock on the RPS to enter the second number.
6) Follow steps 4 to 5 to program the last two numbers.
7) Turn ignition off and RPS Unlock code should be programmed.
8) To enter RPS unlock follow steps 3 to 5
9) If the RPS unlock code is already set and you set the Valet Switch then it overwrites the first two digits of the RPS code
2. Reservation Lock (Manual Transmission Only)
With this option on and when setting up your vehicle for remote start, the vehicle would shut down and arm once all the doors are closed. This option sets
reservation 10 seconds
after all the doors on your vehicle are closed. You are given 10 seconds to open another door to retrieve groceries or a child in the back seat.
3. Auto Relock (This differs from Auto Mode as it is available on all CompuStar systems)
This setting monitors the system and automatically relocks/rearms your CompuStar if the doors have not been opened and system accidentally disarmed. Auto
relock is also useful if you disarm your system and have to go back inside but forget to rearm. You have the option of waiting 30 sec., 60 sec. or 5 minutes before
your system will relock/rearm.
4. Remote Start Runtime
The runtime must be set by your CompuStar dealer. You have the option of having your vehicle run for 3 minutes, 15 minutes, 25 minutes, or 45 minutes. Your
vehicle will run for the set time but you can also reset the run time.
5. Dome Light Supervision
Additional installation may be required for this feature. With this feature on you have dome light illumination for 45 seconds. The dome light will only come on upon
disarm of your CompuStar.
6. Starter Kill
Additional installation may be required for this feature. This feature disables the vehicle when the CompuStar is armed and alarm triggered. When starter kill is
enabled you are unable to start the vehicle with the key.
7. Anti Grind
Additional installation may be required for this feature. When you remote start your vehicle and disarm and enter you must put the vehicle’s key in the ignition and
turn it forward. When you turn the key forward there is a chance of overturning the starter. With anti-grind installed then you cannot over grind your starter on your
vehicle.
8. Anti-Jacking