Installation Instructions
Genuine Accessories
Glasses Gloves
Mask Hearing Protection
Technical Support
1) Read the entire Installation Instructions prior to beginning the installation of the part.
2) Make sure the vehicle is completely clean and dry in the area(s) the part is to be installed.
3) Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
4) NEVER place tools on painted surfaces, seating surfaces, dash pad, console or floor carpet/mats.
5) Always wear appropriate personal protective equipment, including gloves, safety glasses, etc., when required.
6) Record radio presets prior to disconnecting battery power, if needed.
7) Roll down the driver's window and adjust the power seats (if applicable) prior to disconnecting battery power, if needed.
8) Vehicle should be at room temperature.
9)
PMN Foglamp Transceiver System
보호 매트
Language English
2019-04-19Rev. Date
Accessory:Vehicle Model:
Difficulty stated above reflects the minimum level of
expertise required to install the accessory:
( B )
Wireless fog lamp Assy'
(A) Customer
TBD
Difficulty:
Part No.
Model Year 2020~
TBD
Note:
Trim Removal Tool
Electric
Screwdriver
(C) Master Technician or Specialist
(B) Dealer Technician
Application Notes
Denotes quality processes to be checked
prior to moving to the next step
Denotes personal protective equipment (PPEs) that
may be required for a step. Examples of safety
equipment icons noted below:
This Kit applies to 2020~ Model Year (TBD) Vehicle Models.
Vehicle should be equipped with automatic transmission, power door locks, and power windows. If these features are not equipped on the vehicle, do not proceed with install.
Denotes warnings that may lead to serious
physical injury or vehicle damage
Instructional Symbols / Definitions
Basic Required Tools
N
O
T
E
Denotes important information to be
reviewed during the step
Denotes specific tools that are necessary
to complete a step
#2 Phillips
Screwdriver
Denotes cautions to be taken to avoid
physical injury or electronic component
damage
Pliers
Ratchet 12mm Socket
Clip Remover
Denotes cautions to be taken to avoid
vehicle and component damage
ø26 Hole Saw
Notes to the installer:
10mm Deep Well
Socket
Extension Torque wrench Wire Cutters
Factory wire harness colors are subject to change, please use the specified pin # in the connector to identify the correct wires for the two T-Tap installations.
50/50 Isopropyl
Alcohol (70%) and
Water Mix
Clean Cloth
Revision Date
04/19/2019
Page 1 of 20
Confidential