User Manual By Firstech LLC, Version: 1.0 Applicable to the following remote(s); 2WQ9R-FM 2Way 5Button LCD Remote Model Name FCC ID IC Number 2WQ9R-FM VA5RCL300-2WFX 7087A-2WRCL300FX ANT-2WFMX VA5JA1000-2WFX 7087A-2WA1000FX WWW.COMPUSTAR.
WARNING It is the responsibility of the vehicle operator to ensure that their vehicle is parked in a safe and responsible manner. (1) When leaving the vehicle, it is the user’s responsibility to ensure that the gearshift lever is in “Park” in order to avoid accidents upon remote starting. (Note: Make sure that the automatic vehicle cannot star in “Drive”.) (2) It is the user’s responsibility to ensure that the remote starter is disabled or put into valet mode before servicing.
Introduction Thank you for purchasing a Firstech system for your vehicle. Please take a minute to review this entire manual. Note that this manual applies to the 2 Way 5 Button Liquid Crystal Display Remote (2WQ9R-FM) whether you purchased the ALARM IT, START IT, or MAX IT system. There are certain features listed in this manual that may not be available for your system. There may also be features listed in this manual that require additional installation or programming before they are active.
Quick Reference Remote Maintenance – Battery Replacement The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery. Turn the remote over and unlock the battery cover by sliding the black button push. Slide the battery cover off, revealing the AAA battery. IMPORTANT: Be sure to observe correct polarity when installing the battery. 2 Way Remote Button Functions Button Duration Short(0.5 sec) Double Long(2.5 sec) Short(0.
Function Button Menu Button Duration Double or Description Enter remote menu Long(2.5 sec) Exit remote menu Short(0.5 sec) Remote menu selection and operation. Short(0.5 sec) Move to the up of the remote menu Short(0.5 sec) Move to the down of the remote menu Remote Option Menu Table Feature Passive arming Select Function / Description Passive arming On/Off Alert mode Sets your remote for Alarm or Starter Only systems. Set to FULL for ALARM IT and MAX IT features.
Sound/Vibration Turns the silent mode on or off. Adjust the volume of your remote. 1 is the lowest. 3 is the highest. Screen timeout Adjusts the time your LCD will stay on after a button is pressed. Timer start Timer Start On/Off Drive lock Drive Lock On/Off 2nd car mode 2nd Car Mode On/Off Shock sensor Shock sensor On/Off Siren Siren On/Off Auxiliary Extender Button Table Button Duration Description Short(0.5 sec) Auxiliary 1 Short(0.5 sec) Auxiliary 2 Short(0.
Description of antenna module installation position << Antenna Module >> << Harness >> << Installation of Antenna Module >> Note: Use the power of car battery(+12volts). The Antenna module have been calibrated for horizontal installation at the left-top corner of the windshield. Remote Coding / Programming Routine IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.
Remote Start Error Diagnostic If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash again corresponding to the error table.
Limited Lifetime Warranty Firstech, LLC Warrants to the original purchaser that this product shall be free of defects in material and workmanship under normal use and circumstances for the period of time that the original owner of this product owns the vehicle in which it is installed; except that the remote controller unit for the period of one year from the date of installation to the original owner of this product.
