User manual

Maintenance
myUTN User Manual 109
[Phase 1] Reset [Phase 2] Restart
Switch off the UTN server
(interrupt the power supply).
Switch off the UTN server
(interrupt the power supply).
Press and hold the reset
button.
Switch on the UTN server
(establish the power supply).
Switch on the UTN server
(establish the power supply).
Wait until the activity LED and
status LED blink
synchronously.
The reset mode has been
activated.
Release the reset button for
about 2 seconds.
The LEDs blink alternatingly.
Press and hold the reset button
again.
The LEDs blink synchronously.
After a few seconds, only the
activity LED will blink.
Release the reset button.