User manual

Network Settings
myUTN User Manual 35
3 Network Settings
What Information
Do You Need?
• ’How to Configure IPv4 Parameters’ Ö35
• ’How to Configure IPv6 Parameters’
Ö38
• ’How to Configure the DNS’ Ö40
• ’How to Configure SNMP’
Ö41
• ’How to Configure Bonjour’
Ö42
• ’How to Configure POP3 and SMTP (only myUTN-80 and later)’
Ö44
• ’How to Configure WLAN (myUTN-54 only)’ Ö47
3.1 How to Configure IPv4 Parameters
TCP/IP (Transmission Control Protocol over Internet Protocol)
forwards data packets across several connections and establishes a
connection between the network participants.
The boot protocols DHCP and BOOTP belong to the TCP/IP protocol
family. You can define various IPv4 parameters for an ideal
integration of the UTN server into a TCP/IP network. For further
information about the assignment of IP addresses, see: Ö13.
What Do You Want
to Do?
 ’Configuring IPv4 Parameters via the myUTN Control Center’
Ö36
 ’Configuring IPv4 Parameters via the SEH UTN Manager’ Ö36
 ’Configuring IPv4 Parameters via the InterCon-NetTool’ Ö37

You can define various settings for an ideal integration
of the UTN server into a TCP/IP network. This chapter
explains which network settings are supported by the
UTN server.