User manual
Network Settings
myUTN User Manual 37
ª The settings are saved.
Configuring IPv4 Parameters via the InterCon-NetTool
Requirements
; The InterCon-NetTool is installed on the client, see: Ö28.
; The network scan via Multicast has been enabled in the
InterCon-NetTool.
; The router in the network forwards multicast requests.
Proceed as follows:
1. Start the InterCon-NetTool.
2. Select the UTN server from the device list.
The UTN server is displayed in the device list under 'ZeroConf' with an IP address
from the address range (169.254.0.0/16) which is reserved for ZeroConf.
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the Wizard.
ª The settings are saved.
Fig. 7: InterCon-NetTool - IP Wizard